Bad Bulldozer wPrime performance

[I.M.O.G.]

I'm running on the same OS I use for thuban and deneb, however on Bulldozer if I match frequencies that others are running, my wprime scores suck. For example, wp32m would be .3s behind someone who is running the exact same settings.

This happens on both my fx-6100 and fx-8120. I have 1st in most categories on both chips, but to do so I'm running much higher frequencies. I have to run about 300mhz faster than anyone else to match their scores.

Any tips on what I might be missing?

You can review my submissions at the following url's:
http://hwbot.org/search/submissions/permalink?username=I.M.O.G.&cpuId=2398
http://hwbot.org/search/submissions/permalink?username=I.M.O.G.&cpuId=2457

[I.M.O.G.]

Nevermind, I was killing a process that had to do with my 3d drivers, which then caused extra cycles on the CPU. My fx-6100 scores are fixed now, just need to rerun the 8120 wprime submissions. :)

[Massman]

I was gonna reply "comes with the hardware", but I see you figured it out already.

[I.M.O.G.]

heh, should have titled it "worse than normal" instead of "bad".