Vengeance @ 3000c9 32M air

Decided to give this Vengeance kit a shot. I've had it in the office for a while now, and never really pushed. Country Cup gives me a bit of motivation to see how good they are.

Turns out they're not that bad

System pics

^Great kit of Samsung PJ

1500 x-12-12-x on air is by far the best Samsung I've seen.

Too sad these kits are not available for mortals.

It's one of the kits binned for the Computex event, I think. Can't really remember where they came from, they've been sitting on the shelve for 6 months .

But yeah, those kits are just special bins. Not possible to find in retail, I think.

Here's a 1500 stable run http://hwbot.org/submission/2465734_massman_superpi___32m_core_i7_4770k_7min_26sec_438ms

With tight subs I've gotten it to loop 18/19.

No optimization of subs in that 7min26 run. Seems like 4GHz low-clock demands low latencies, not high frequency.

Yea those kits are sick!

I did 1472 MHz 9-12-12-19 1T in Quad Channel yesterday

Run 32m several times.

1500 in Quad Channel should be easy aswell.

Damn, in quad that's awesome. Ambient air too? What voltage?

Yea just air cooling. 2,05 Volt =)

Show us some 3Dmark physics madness Pieter

Doing 1500 9-13-13 at ~2.4V is not hard even for "just above average" Samsungs, 1500 x-12-12-x is a totally different ballgame.

Doing 1500 9-13-13 at ~2.4V is not hard even for "just above average" Samsungs, 1500 x-12-12-x is a totally different ballgame.

Agreed need some pretty good kits, I have 16 dimms to retest one by one after Country Cup.

On Haswell the best Dom Plats, need 2.00v to run 2872 9-12-12-16 with everything yoked out.

Due to the nature of Ivy E's IMC, I feel that it is much easier to run higher clocks, even in quad channel because it is not nearly as stressful as Haswell on the ram.

Great ram PJ, now time to start tightening subs

So you say I should retest with IVB-E too?

I don't have a R4BE tho, and I don't think there is any point trying another board. Maybe the Evga or so.

Mass how about an efficient run? You need to shave some major seconds show us the money

Haha, yeah. Anything over 7min20 is embarrassing really. Wish I could try this on an OCF too.

I have Value RAM G.skill RipjawsX F3-12800CL9-2GBXL can run 2800 9-12-12-15 2T 1,995V on Pentium G3220. I think need a better processor for try higher memory clock.

picture

https://scontent-a.xx.fbcdn.net/hphotos-frc3/1475972_767261906620579_454034809_n.jpg

So you say I should retest with IVB-E too?

 

I don't have a R4BE tho, and I don't think there is any point trying another board. Maybe the Evga or so.

You don't think the original R4E would suffice?

For memory clocking, I think the R4BE should be a lot better as it was tuned for IVB-E.

Isn't there a limit on the r4e for mem voltage? I couldn't set over 1.92 volt on my board..

Anyone got a spare set of 2666c10 dom or vengeance?