Jump to content
HWBOT Community Forums

Nvidia 8800 GTX/Ultra reference PCB G80


der8auer

Recommended Posts

Nvidia 8800 GTX/Ultra reference PCB G80

 

Pics of the card:

attachment.php?attachmentid=1731&stc=1&d=1388343168

 

attachment.php?attachmentid=1732&stc=1&d=1388343168

 

 

 

vMods:

For the 8800GTX the voltage for the G80 GPU and GDDR3 memory can be read out at the following places:

 

attachment.php?attachmentid=1707&stc=1&d=1388340087

 

Just like we showed on previous page you might want to solder a couple of wires to those readout spots so that voltage reading is easier once your card is being installed in your housing. The default voltage for the GPU is 1,3V; the default memory voltage is around 1,95V.

 

GPU Voltage Modding

 

attachment.php?attachmentid=1708&stc=1&d=1388340087

 

 

You need a soldering mod for this one, therefore one must connect a 500 Ohm variable resistor between the marked spot and any ground. To increase voltage you must lower the VR's resistance, so always make sure that your VR is set to highest value before you turn on your pc.

 

MEM Voltage Modding

 

attachment.php?attachmentid=1709&stc=1&d=1388340087

 

For the MEM voltage mod we must search for the small AT PWM IC. The marked resistor is the one you need to shade with your B2 pencil. Strike it a few times and measure how the resistance changed.

 

You can also try the soldering mod, therefore one must connect a 20 kOhm variable resistor between the marked spot and any ground. And again you must lower the VR's resistance to increase voltage, so always make sure that your VR is set to highest value before you turn on your pc.

Edited by der8auer
Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...